Invisible locomotive

[celje]

A strange thing was happen in TS10. In surveyor I try to put in new train with locomotive DB x72500 but loco is not visible and can't set in ''driver'', delete is not possible also and the other trains can't drive in this section. I cloned the route and the sesssion, made ''Delete Missing assets'', run ''Database repair'' but no success. Any help please, how to delete this locomotive.

regards

 

[celje]

Can somebody help.
And something more, if i make the collision with another loco (manuel guided) then DB show up. Deleting session doesn't help too because loco was saved with route leyer.

regards

 

[Tokkyu40]

I didn't know you could save a locomotive to the route. I thought the rolling stock only went with the session. Is this something new?
You might have to go into the files and delete it manually, then go back to the route and try the delete missing assets.
Delete missing assets won't work now because it's not actually missing. It's on the hard drive and in the route, it's just not visible.

Claude

 

[celje]

Thank you Tokkyu.

After open ''Edit route'' i see in surveyor all my trains on the tracks, but the ''Driver setup'' has not schedule. It doesn't matter if i delete session before. I think that i hava marked the route layer when i saved changes in session.

Yes i tried disabled loco in CM3 (it's impossible to delete it, only enable/disable) and then in surveyor try to delete it, but don't work.

regards