Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
The rule is working in trs19 but not trs20 pe and plus, I'm scratching my head also. I intended to use it to automate a turntable.I am having the same problem with Trainz 2022PE SP4. I am continuing to explore to see what I might be able to do, but this minute I am at a dead end.
Update to add: I checked a route that uses InputTable for some turntables. The route was downloaded to 2022PE and works fine, but I cannot add any new information. I guess I can edit a route in 2019, but some 2022 routes are incompatible with 2019.
Hey Stagecoach, are you able to explain how EIT would work setting up a turn table for AI use with all dependancies if you have time. Thanks.The rule is unnecessary now as EIT has taken over the path selection and there is a driver command to move the turntable.
Thank you for the pointer to the Move Turntable command. I will use that going forward.EIT won't work like the input table in your case. You need <kuid:458053:108204> Move turntable -command.
Drive the engine onto the turntable as you would have done, then add the above driver command, it will allow you to select which number to rotate to.
It does away with the input table and no setting up is required.
I have tried this, but was not successful. Then I learned in another thread "There is an issue with SP4 where once you've set a window to maximum you cannot then minimise it again - it always defaults to maximum. Even restarting Trainz doesn't fix it." In the other thread several folks say it's been reported as a bug.Have you tried moving the input table widow to another position before clicking on add '
I'm not having any problems on build 126280
Peter
Thanks, that doesn't work for me I need to move turntable to the appropriate roads for roundhouse engines first.EIT won't work like the input table in your case. You need <kuid:458053:108204> Move turntable -command.
Drive the engine onto the turntable as you would have done, then add the above driver command, it will allow you to select which number to rotate to.
It does away with the input table and no setting up is required.
Move Turntable command doesn't work without rule?Just use the command before you drive onto the turntable.
Move turntable = to roundhouse track
drive to turntable TM
Move turntable = to leaving track.
That explains it, I was using <kuid2:609850:100018:1> Move Turntable. I will download the right one and try it. Thanks a lot, I'll let you know.Do you have the kuid I mentioned? it does not require a rule.
<kuid:458053:108204> Move turntable -command.
Just add to a driver's command list.
