Help setting junctions in new session.

Cnyle2101

New member
I am trying to learn session making but I have come to a point that I cannot figure out. The junctions are already laid out for the route but I want to change one but I can't seem to be able to. I have added the command but it stays in the same direction. Will it change once I get to that point while driving in the session?
 
@Cnyle2101 >>> Open the Track menu, on the right side of your screen > Then choose the center icon, top of the menu "Trackside Mode". then at the bottom of that menu choose the Junction direction icon > change the switch direction by mousing over the switch arrows, and clicking a direction.

This is also done in Driver by mousing over a junction and clicking a direction arrow.
You can also click the arrows in map view, which is sometimes easier when junction points are parallel or very close together on a single-track.


Wiki-link
How to control junctions in Sessions


Rico
 
@Cnyle2101 >>> Open the Track menu, on the right side of your screen > Then choose the center icon, top of the menu "Trackside Mode". then at the bottom of that menu choose the Junction direction icon > change the switch direction by mousing over the switch arrows, and clicking a direction.

This is also done in Driver by mousing over a junction and clicking a direction arrow.
You can also click the arrows in map view, which is sometimes easier when junction points are parallel or very close together on a single-track.


Wiki-link
How to control junctions in Sessions


Rico
Thank you! I've been changing it manually during my testing but I couldn't figure out how to set it so it would be the direction I was wanting.
 
@Cnyle2101 >>> Open the Track menu, on the right side of your screen > Then choose the center icon, top of the menu "Trackside Mode". then at the bottom of that menu choose the Junction direction icon > change the switch direction by mousing over the switch arrows, and clicking a direction.

This is also done in Driver by mousing over a junction and clicking a direction arrow.
You can also click the arrows in map view, which is sometimes easier when junction points are parallel or very close together on a single-track.


Wiki-link
How to control junctions in Sessions


Rico
The exact solution I was looking for, thank you again for your help.
 
Back
Top