help needed with built in 2010 house problem

[misterchugg]

hi
i am trying to rename the built in houses to make it easier for me to find them,
but
3 come up as unable to load the .im file

the files are all correct in the folders

i even ran assetx and pm to im

no luck

the last one is missing textures that are in the containing folder

any ideas?

thanks
ron


By mister_chugg at 2011-10-01

 

[fran1]

Morning Ron,
First off open (for edit using explorer) the built in ones that now show as faulty and close them using revert to original.
Now click on one and in asset details (on the left) scroll down until you find the name, alter it to suit.

 

[Deano5]

Morning Ron,
Now click on one and in asset details (on the left) scroll down until you find the name, alter it to suit.

This is interesting, can this be done with any asset? It sure would make finding "DT House" and "53ZP House" a lot easier with the word House at the front. :wave:

 

[misterchugg]

morning fran

that worked mate,

but how can i save it so that when i do get a crash
i can replace it

when i have gone through the houses, farm, shop, commercial, factory and cars categories
then i will try to archive the lot onto disks
so that i done have to rename them again

any ideas on how this can be done with these?

thanks mate
ron

 

[rweber95]

Highlight the asset in CM. In the Asset Details Panel edit the name in the Asset Name box. CM will now show that kuid with the new name.

Bob Weber

 

[baz66]

deano.
You can change them. Make sure its the username in the config file. Best done with notepad. Don't change the language ones. If errors shown on built in, you can revert to original.
baz