HELP! How to replace a custom object in TO.

[jeffjgale]

I replaced my track [ NG30 Track (brown)] with a Custom object [MB_NG_TRACK_3_NO_BALLAST ] which I thought was just a 3ft NG track. Now I have nothing on my 18 board layout but a continual trestle bridge just under the ground that I can not replace, as it is in the Custom listing of TrainzObject which does not give me a replace in the right click menu. HELP Please. :'(

Jeff.

 

[narrowgauge]

Jeff

If I read you right, you are trying to do this from the normal grid of listings. Replace is only available in the map content list.

Reselect your map again and allow TO to to remake the contents listing. Your new 'endless linear bridge' will be in the list. Now you can do the 'Select and F7' routine to replace it.

Cheers

Narrowgauge

 

[jeffjgale]

Thank you Peter, I nutted it out myself.

Thank you Peter, I nutted it out myself.
Opened my map and clicked on the "Wireframe" tool, then opened the "Track menu".
Clicked on the "Get Track" tool and clicked on the Trestle showing on the map in wireframe view.
Found that the object was called Narrowgauge Trestle Spanner not MB_NG_3_NO BALLAST track that I had clicked on to do the replacement with in the first place [Must have been the Trainz gremlins].
So just went into TO and replaced this with some track. UREKA !!!!!
Lost one small section, but that is better than the whole lot.

Thanks heaps. Jeff.