HAM radio tower?

Will this type of aerial do the job?



The mast is 40m (120ft) high and has a 10m (30ft) aerial on top and triple straining wires
If this is not realistic let me know what the measurements should be.

Cheers,

Bill.
 
G'day Bill

The tower you created would look right at home at a commercial installation, ie HF Military, Aviation or Maritime or a super rich Amateur (Ham) Radio operator.

The lower part of the tower has an antenna which looks like it's for VHF use (Vertically Polarised), generally, it would not be that large and would be higher up the tower.

Most home antenna towers are between 6 to 12 metres high and would have a rotating device (usually electrically powered) to slowly rotate the antenna for correct heading.

Some Ham antenna towers have a triangular base and do not require guy wires for support.

I think you should create both size towers and antennas. The work you have shown is truly remarkable and is always appreciated.:)
 
Thanks Larrymoecurly,

will modify the lower aerials and do a 12m version.

Any extra info is much appreciated, have seen them but
know nothing about them.

Cheers,

Bill.
 
Modified Commercial Aerial,


and the 12m home version,


If you think it is ok I will upload them.

Cheers,

Bill.
 
Bill

Your modified models look excellent. Well Done. All of them should be uploaded, as although, most towers are similar looking, the actual antennas differ in size, because of the different radio frequencies, that are transmitted by the ham radio operator.

Here is a commercial site <http://www.texastowers.com/>, under their catalogue section, you can see many different types of towers and antennas. For your future reference only. Thank you once again for your great work.
 
Note that the tower is free standing.

(odd that I am not allowed to edit my above post)
( but I am allowed to edit this one)

The tower sets on/in a concrete base.
 
Last edited:
Radio communication is much needed in Trainz!
Many thanks from a fellow Ham.

73's
KC2RXO

Speaking of train communications, I seem to remember a while back that there were UHF antennas along the railroad right-of-way for routes that were out in the boondocks - especially ones in hilly country. They acted as a repeater for the hand-helds in the cab and by personnel along the train to the ops center.

They looked like the top antenna on the mast (but reduced perhaps another 50% for frequencies in the 420-450Mhz range). They were sited beside the track and usually pointed down the track. Sometimes there were two: one pointed one way and the other pointed opposite. Height above ground depended on the terrain. I would imagine that if the mast was made, say, 10m tall, it could be 'pushed' into the ground to appear shorter.

I wish I had the talent of content creation, but I am definitely bad at it. My first experiment (a house) with Gmax turned out the size of a football stadium. A person standing in front of the front door would hear the opening strains of 'Also Spracht Zarathustra' ("2001" main theme).

Bill
 
Last edited:
Speaking of train communications, I seem to remember a while back that there were UHF antennas along the railroad right-of-way for routes that were out in the boondocks - especially ones in hilly country. They acted as a repeater for the hand-helds in the cab and by personnel along the train to the ops center.

snip
Hi Bill,

I have seen the ones you mean, will do something in that line.
The others have been uploaded and are awaiting approval.

Cheers,

Bill.
 
That would be great, Bill. There weren't any guy wires or anything, just the mast itself. I've even seen them atop signal towers and light poles.

Bill
 
Hi Bill,

These are the ones I have seen, is that similar to what you are talking about?
If not, if you have a picture send me an email (address still up above).




Cheers,

Bill.
 
Last edited:
That's exactly what I was talking about. Are they already on the DLS? If so, I haven't been able to find them.

Bill
 
Back
Top