gaps at bridges

[jspaughton]

can anybody tell me how to fill in the gap between a bridge support and an embankment.

 

[quoz]

can anybody tell me how to fill in the gap between a bridge support and an embankment.

What I do is set the bridge much narrower than required, attach road or track spline, and use the spline leveller. Then I move the bridge back to it's proper width.

 

[Capt_Haddock]

Bushes and small trees

 

[rjhowie]

That's a good reply. I have been building a whole rail system and rather than raise the ground to the track at embankments I have used grass embankment splines so the embankments are not too wide and not as in real life. A bit more fiddly effort needed I know but I then can put in spline points and curve them into say where road bridges go under the railway along with some bushes. Looks better for me!

 

[jspaughton]

thanks for the ideas. I'll try them out.

 

[vosloo]

thanks for the ideas. I'll try them out.

Hi, You can also use Bridge end concrete, darkstone or stone. KUID 46162:24001.24002or 24003. You might need to place more than one.
Hennie

 

[jspaughton]

thanks for that vosloo. I'll try that as well.