draw problem

baz66

New member
I have read a few posts on nvidia and problem solves but they do not appear to be the same as mine, therefore any advice would be helpful.
I have a nvidia 8600 GT card, 2gig ram D2 MB?.
My problem is and only occurs on my own route.
1 The draw distance is reduced to 1 or 2 boards and slowly starts to displayout.
This is only a 4 grid route. Comparison. Northern ohio draws immedialy to the full distance (5000 mtr)
2 Stop start periods of up to 3-4 seconds. Placement of items will cause it to stop and redraw everything.
3 Items will display in some places but not others (especialy trains.) If I move 50 meters down the track, I can place.
4 The driver session (auto) is not smooth.Stops and starts every few second. comparison. NOhio run very smoothly with a 1500ton consist.
Someone might know the answer. I have run EDR (deleting asset.TDX) but no help. This is only in my 2010 version and again, Only on my own route.
baz
 
Thanks clam. I'm sure your'e right. Ihad cats on 1 double track which I took of. That helped a lot. I'll change fences as suggested and see if that help. Here's a funny one tho' I have a consist coming into a container terminal to unload GGs
It unloads alright but each wagon then shows 56 fertiliser bags. Never seen that one before. The workers must be very busy down there.
baz
 
baz66: I would check your drivers and see if there up to date..Nvidia has a scan to see if your up to date..Check the requirements of 2010 to see if your computer is qualified..
 
Back
Top