Decoupler missing.

[AntonyVW]

Hi guys. Im hoping someone can help me. I have been setting up an AI in surveyor. I want to ask the consist to decouple a wagon but the decouple rule is missing from the list. I have been to the driver command to make sure it was checked and it is. However it is missing off the LH context menu where I set up the rules for the consist. Ive also checked in quickdrive and it is missing there. I can't think why its missing when it was there last time I came to use it, and according to driver command it is selected. Short of re-installing the game I dont know what to do about it. This is TS12 btw. Can anyone help please?
Thanks
Antony

 

[shaneturner12]

The standard Decouple command is not available in Surveyor.

You will need to use an alternative like Uncouplez or similar.

Shane

 

[AntonyVW]

Thanks Shane - but it is also missing in driver mode too.

 

[shaneturner12]

If it's missing in Driver mode, check that it is ticked in the Driver Commands list. Also be aware that it can be a bit buggy, as it checks to make sure there is a consist before it shows up.

The Uncouplez (or similar) commands will appear in both modes.

Shane

 

[AntonyVW]

It is definitely in the drive command and it is selected. I will try the uncouplez instead. Thanks

 

[Ricke82]

You might also take a look at UnCouplezFrom (kuid:66277:80005) also by smileyman. It works both in Surveyor and Driver and allows you to specify what you want to uncouple from by its location in the consist.