Coupler breakage and crashing to Desktop on TS12

[vernongt]

Anyone help me with why my TS12 crashes to Desktop when using the Mojave Sub Division?
I tried the top Session, and it crashes before I even get 10 feet along the track.
I retried - same problem...

Rebooted Windows and tried the Mojave to Bakersfield session and only got a few miles down the track and I got a coupler breakage????

Same thing happened with the other version of TS12 [JustTrains RR Sim by TS12]???

I passed all my tests during installation!

Confused...
Vernon

 

[clam1952]

Known problem, several threads on the subject, should be fixed in service pack 1 whenever it gets finished.

 

[vernongt]

Thanks Malc,
I "Googled" a couple of questions and found that one bloke went to Surveyor and Edited the Session, and removed the Physics Rules.
I tried it with the #991 Session [2 hr one], and saved as "HotShot #991-1" [or whatever the actual name was, and then ran it again.
I actually went pretty far before it crashed again; but this time, I think a "Windows 7 Update" caused the 'crash' that time.
So, I went and edited the second Session [Mojave to Bakersfield] and saved IT as "Mojave to Bakersfield-1" then before I ran it, I shut down the Wifi ISP and also my Capture Wiz Pro and Microsoft Security Essentials [which run all the time].
I then took that session for a run and it went at least 5 times further than it ever did before it finally "Crashed to Desktop" Grrrrrr!

Still looking and searching for help on this.
Is the Service Packs available through the CM???

Cheers for now.
Vernon

 

[clam1952]

The service packs are usually either automatically downloaded or you can get them manually, it's not ready yet though as apparently there are some problems with it, should be an announcement from N3V when it's available.
There was a post on here somewhere that indicated there was a possible track fault causing the problem, which tied in with the visible Jolt I get just before the couplers break, the same jolt you get when going over a wrongly set point or switch, can't find it now though.

 

[Robert2d6]

I think you have to figure out if Trainz is crashing to desktop as you are claiming, or you are getting an end of session because of a coupler breakage. These are two totally different things. Once you sort that out, maybe we can help you.