anathoth71
Member
Greetings Surveyors,
I moved up to TANE SP2 from TRS2010 recently, and am in the early stages of building my first large new route in TANE. I intend to use the Select Area function (set to objects only) and then Paste Area to start laying lineside foliage and it isn't working well.
The area I copied from is at a lower elevation than the area I tried testing the Paste function at, and the paste itself seemed to work, but all the objects were added to the route at their original (much lower) altitude, instead of assuming the ground level where I pasted them. With textures off I can see them way down there underground, presumably at the same altitude they were copied from.
I searched the forum and found some bug reports from earlier TANE versions, but couldn't find a simple solution. Have I just got a setting wrong somewhere?
Thanks in advance.
I moved up to TANE SP2 from TRS2010 recently, and am in the early stages of building my first large new route in TANE. I intend to use the Select Area function (set to objects only) and then Paste Area to start laying lineside foliage and it isn't working well.
The area I copied from is at a lower elevation than the area I tried testing the Paste function at, and the paste itself seemed to work, but all the objects were added to the route at their original (much lower) altitude, instead of assuming the ground level where I pasted them. With textures off I can see them way down there underground, presumably at the same altitude they were copied from.
I searched the forum and found some bug reports from earlier TANE versions, but couldn't find a simple solution. Have I just got a setting wrong somewhere?
Thanks in advance.