controls
- Thread starter broseph
- Start date
Hi broseph,
There should be a lever at the points showing a red and a green arrow, if it is there just left click your mouse pointer on it to change. If it is not there you will have to add one. Bring out the tab with the rail on it then left click on the centre icon, then in the very yop line of the little window type lever. Left click on the word lever in the window, left click on the plus sign icon then left click on the track near the points. If the arrow shows two reds left click on the move icon, second from top, then left click and hold on the lever and drag it farther away or closer to the points till it shows a red and a green.
Hope this helps,
Bill69
There should be a lever at the points showing a red and a green arrow, if it is there just left click your mouse pointer on it to change. If it is not there you will have to add one. Bring out the tab with the rail on it then left click on the centre icon, then in the very yop line of the little window type lever. Left click on the word lever in the window, left click on the plus sign icon then left click on the track near the points. If the arrow shows two reds left click on the move icon, second from top, then left click and hold on the lever and drag it farther away or closer to the points till it shows a red and a green.
Hope this helps,
Bill69
robin_hoods
TrainzDiag troubleshooter
Hi if your loco is to close to the point or points you wont be able to change them.
An easy way is to stop the loco well before the point press M = map, on here if you zoom in you should be able to see the next point along and left click to change it then press M again to go out of map and then re start loco
An easy way is to stop the loco well before the point press M = map, on here if you zoom in you should be able to see the next point along and left click to change it then press M again to go out of map and then re start loco
Hello Broseph,:wave:
..............Is it the keyboard controles you are looking for
............If so they are the (J key) for forward faceing points and (Controle + J key) for rear faceing points, but this method only changes the nearest points to you, if you have two sets of points close to each other you woun't be able to change the second set of points, this way!
..............Is it the keyboard controles you are looking for
............If so they are the (J key) for forward faceing points and (Controle + J key) for rear faceing points, but this method only changes the nearest points to you, if you have two sets of points close to each other you woun't be able to change the second set of points, this way!Similar threads
