changing juntions

[NYCboy]

i now how to change jucntions but the problem is that it takes away the adventege of me sitting in the egnineers seat.i have to go to get a view out of the train and change the junction.so is there a way i can change the junction from the cab view in trainz classics?

 

[Zwabberaar]

Press the "J" button.

 

[wmmeyer]

I think the "J" key will work in cab view. J will change the forward junction, and Ctrl/J will change the rearward junction. Probelm is ya can only change one junction either ahead or to the rear. Then ya have to wait until ya clear that junction before ya can change the next. When I get into a close situation, I usually switch over to map view, change all I need and then resume in cabview.

 

[llebrez]

There is a rule I think called "trakview". Once installed you will see a square at upper left corner showing the track ahead with all the signals and turnouts, distances and everything. Just click on any turnout and you change it no matter how far or near it is from the cab. To switch a rear one, just reverse the direction and it shows the line at the back of the train. A genius made it, but I don't have the kuid on hand now. Anybody..?

 

[Swordfish]

That was KlausM. But he has retired his content from the DLS and from all other pages. :'(

Regards

Swordfish

 

[collinsl]

Does CTRL + Click work?

 

[Koondawg]

I think the "J" key will work in cab view. J will change the forward junction, and Ctrl/J will change the rearward junction.

I found this to be very helpfull...TY

Koon

 

[JCitron]

Does CTRL + Click work?

Yes it does, but be careful if you're in a place with a lot of junctions.:hehe:

John