C ccowan2126 Member Jun 22, 2010 #1 How can I put a tunnel thru a mountain? I can't figure out where there is a tool for doing that. Thanks.
How can I put a tunnel thru a mountain? I can't figure out where there is a tool for doing that. Thanks.
M Muliebuck New member Jun 22, 2010 #2 As (most) tunnels are splines, select the tracks tab (F4), place the start of your tunnel (it'll lock to a grid square), then drag it out however long you want and click again to place the 'end' of the tunnel.
As (most) tunnels are splines, select the tracks tab (F4), place the start of your tunnel (it'll lock to a grid square), then drag it out however long you want and click again to place the 'end' of the tunnel.
B BobCass New member Jun 22, 2010 #3 Hi: Just a added note to what was said above..In surveyor mode put it wire mode and this Will let you see where it is..
Hi: Just a added note to what was said above..In surveyor mode put it wire mode and this Will let you see where it is..
