ATLS INVERSE SLAVE?

[selector]

Maybe me having an brain disfunction, but just changed from 2009 to 2010 and im'e sure that I set-up the inverse slave to stop trains from going over the level crossing until signals clear. What I get now is trains will not approach the crossing as if there is no path to follow to it's destination the atls crossing functions ok (not the all in one but the modular bits) but still says that a train is occupying the track ahead. Does the inverse slave work in 2010 or am I doing somthing wrong? Thanks for any advice.

 

[stagecoach]

Yes all the ATLS items work fine in 2010. I would first check they all have the channel information correct as sometimes if moved they will default. Ive also found, depending on the type of signal used, that you may need to have a larger gap between the signal and the slave. This also applies to the triggers if they are to near can cause a problem.

 

[selector]

Thanks Stagecoach will give that a go

 

[selector]

Just tried your suggestion on a test route Stagecoach, yep that was the problem signal too close to inverse slave thanks again.