Any way to hide spline circles while working on the splines?

[Red_Rattler]

Any way to hide spline circles while working on the splines? They can get in the way, making it hard to see.

 

[redmonkey]

AFAIK there isn't. However, I always prefer to have them non-rotating.

 

[Paulsw2]

I agree that they can be hugely confusing and get in the way. At the very least it would be helpful if only those splines in the active layer had spline circles activated - splines in other layers are inactive so why bother showing their circles?

Paul

 

[cascaderailroad]

Splines have circles ... You'll just have to get used to seeing them ... If they had no circles, they wouldn't be splines.

One guy wished that he could edit a route in Driver ... No that would be Surveyor ... pick one or the other.

Press Alt U or Alt Y ... to escape, press the Esc key

 

[Red_Rattler]

They already are non-rotating, but when trying to see if the height is correct of a spline, very hard to see through. Obviously I can't hide the layer I'm working on. Cascaderail, they would still be there, but just turned off.

For example, I was adding light rail platforms to NormP's Surfside layout (Don't tell him - The conditions don't say I can't change it!)

I didn't know that the fence on the ramp was slightly "floating" in mid-air as shown below:



This is the same shot if you were working on the spline. It's easily missed with the spline circles not be able to be turn off.

 

[cascaderailroad]

10 charactors

Press Alt U or Alt Y ... to escape, press the Esc key