Adding new load

[CRQ4125]

I'm trying to make an autorack train, and I want to put autoframes on which are available on the JR 52ft bulkheads. I would like to add this to either the JR 50ft TTX flatcar or preferrable an 89ft flatcar. This is what I would like to get

 

[fran1]

try using kuid 95761:15150 ttx 89ft flat. In the config file alter load 1 (it loads 5) from kuid 42796:29001 to the autoframe one.
If you want only autoframes to load, clone the car first and keep only load 1.

 

[CRQ4125]

Edit: This is what I get. Not quite sure how to rotate them.

 

[CRQ4125]

Not sure how to rotate them

Edit: Also, the frames aren't stacked quite as high as I'd like, but can't change that, oh well.

 

[normhart]

One possibility might be to use PEV's PEVSoft Attachment Maker to add new attachment points that are rotated 90 degrees. It might also be possible to add another set of attachment points above the first set to double the height. I'm not an expert or anything, just a possibility. Maybe.

 

[JohnnyC1]

You are using the wrong load queue for the chassis, that load queue rotates the load 90 degrees, use load 4 for 5 loads or load 2 for 4 loads. Also use Chassis Frame 00 Product to Chassis Frame 04 located on the DLS.


Load queue4

Load queue 2

From JR kuid <kuid2:47092:1003:1> Flatcar 60Ft OTTX#

John