2010 Products setup not saving

[loco20]

Hi.

I have been working on a new scenery for 2010 Trainz.
after entering the products setup in surveyor using multi industry new industry track section after placing the loads required and saving the new imputs I test the saved game only to find that the goods that i put in are gone.?

This I have tried six times now and each time it's faild to save it's the same for the drivers duties they go too?

Any help would be very nice please!

 

[Dug]

Are you editing the route or the session when this problem occurs? I believe
you can only save settings when editing the session. Not sure about products or driver commands but I know from experience that the portal settings will only save when editing the session. Actually, to save portal settings, I have to edit the session then click on the layers tab, highlight the route layer then edit the portal settings. Only way I have found that works and works every time. I suggest that you edit the session, then try editing the products in each layer (route and session) to see which one saves properly.

Doug

 

[ct_krogen]

dug

your right the cars trainz, indies setting are done in session not route layer

 

[mrscsi]

Are you editing the route or the session when this problem occurs? I believe
you can only save settings when editing the session. Not sure about products or driver commands but I know from experience that the portal settings will only save when editing the session. Actually, to save portal settings, I have to edit the session then click on the layers tab, highlight the route layer then edit the portal settings. Only way I have found that works and works every time. I suggest that you edit the session, then try editing the products in each layer (route and session) to see which one saves properly.

Doug

Correct all settings to any industries is going to be saved in the session layer only, if you go back in and try to edit the route layer later on they will be blank…