Recent content by Rehnn

  1. R

    Automatically Set Signals / Automatic Signaller

    Is there anyway I can get signals to be set automatically by the AI? E.g. Let's say I want to drive the ECML from KC to Doncaster or maybe take a Deltic on one for the ECML branches. If I just went into quick drive and tried to drive this I may have to do lost of complex switching of points...
  2. R

    Scenarios for East Coast Mainline

    I usually tinker about with Trainz building my own scenery/track for my own private fun. But I've recently enjoyed driving the East Coast Mainline Route. Are there any more scenarios for the East Coast Mainline. I've enjoyed doing the York to KC run bu Inter City 125/class 43 (not completed it...
  3. R

    Driver Command Uncouple/DeCouple (Get AI to use a turn table)

    I'm trying to get an AI Driver to use the turn table to turn around an connect at the other end of a train. I'm not sure exactly how to do this - but I'm guessing it's along the lines of: DECOUPLE - DRIVE TO TURNTABLE - TURN TURNTABLE - DRIVE TO OTHER END OF TRAIN - (RE)COUPLE. The two...
  4. R

    Getting trains to auto change junctions quicker

    I've built a section of a long a toutrous route. I've set up a train to drive from one station to another. When the train reaches a red light it stops - it does eventually switch the correct points so it can continue. Is there anything I can change to either allow the Train/Driver to switch...
See more
Back
Top