Recent content by greymaster

Just installed TRS19 and tried to start it, but all I get is the message "starting trainz" for two hours now. I have a new PC with W10. Any ideas? Thanks.

I PAID BY CC FOR DIGITAL TRS19, BUT I SEE NO EVIDNCE OF A DOWNLOAD. PLEASE EXPLAIN/

I posted a thread asking for instructions to reinstall TANE. Not only was it not answered, but it was moved, with no clue to where it was moved. THANKS EVER SO MUCH.

In TANE SP2, having trouble finding a dependable interlocking tower for use in crossing protection. I have tried the Crowcombe and Enhanced TRC models. Both are buggy and the TRC one loses all input path data when Trainz starts. Does anybody check these things before releasing them to the game...

In TANE/SP2, when a train waits a long time for a crossing or junction to clear, the AI sometimes will shut off and switch control to Manual. What kind of AI is this? I could understand the AI shutdown in case of a wreck or other abnormal condition, but why shut down in a normal situation ? Is...

In TANE/SP2, trying to set up protection for a diamond track crossing. I used the Crowcombe interlock tower and Safetran signals. The crossing is protected for sure, as both trains stop and stay stopped. Cannot find why this is happening. Does anybody have any experience with this? Thanks

In TANE SP2, I have placed a "dk crossing gate" and a trigger, trying to set it up so that the gate is down when a train is on any part of the trigger. My problem: I cannot see any way to make the connection between the gate and the trigger. (Would it be better to use a "track circuit detector"...

Looking for a way to simulate wet (rained on) streets. Also looking for people that are walking (in motion). I did find some RR workers that are waving, etc, but no walkers. Thanks for any ideas.

I would like to try 5mm grid setting, changed the setting in topology tab from 10mm to 5mm, but nothing happens. The manual has nothing on this. Anybody know the correct method? Thanks.

In TANE SP2 route, I have placed track direction markers to control direction on a reversing loop, but AI trains run against them as if they were not there. However on my test track they seem to work fine. Anyone else having this problem ? Thanks.

I have a medium sized route with about 30 trackmarks, built in TANEsp2. An AI train commanded to navigate or drive to a trackmark does so successfully except for one particular trackmark: the train will not find the trackmark, or simply drives past it, sometimes stopping after a couple miles...

In TR2006 I routinely ran trains in opposite directions on single-track line with passing tracks, and the AI worked perfectly to control the trains and switch junctions at meets, allowing trains to pass. Now in TANE SP2, when trains meet the AI will not switch the junction. I have tried...

In TANE sp2- Curved track often has horrible kinks and appears as short sections of straight track rather than a smooth curve. It happens with any type of track, and any size of route. This problem never appeared in Trainz 2006. Any thoughts? Thanks.