Srobertson1956
Member
After downloading a route from a reputable 3rd party provider the main CDP file is grayed out and says "Open for edit, missing dependencies”. I checked all of the assets and found only a few missing. The designer sent me those. But still the file will not “verify”. My process was:
I downloaded the file from the site. Moved it into the Routes and Sessions section of the content manager, then after a few minutes I checked for missing or faulty stuff. There a couple of assets that will not correct: a PBR-mud 4 asset that says it is "installed from DLS, faulty". Another scrap metal assets says "Open for edit, faulty". But still the main file name is grayed out. Hard to believe a PBR texture and a another simple asset is holding this up.
Any thoughts on what I might be doing wrong? I talked with the designer but he can not see why this will not load. Others have downloaded same file with no issue. I have other routes that I have created or downloaded from a 3rd party that are missing dependencies and they still load and run, just some stuff missing. I can not get this route to the point of verification (no gray) so it does not recognize/show up it when I try to run the route.
I am running a MAC but that has not stopped other 3rd party downloads before.
I looked through the WIKI pages and could not find anything relevant to this issue. Any input you have is grateful. Thanks.
I downloaded the file from the site. Moved it into the Routes and Sessions section of the content manager, then after a few minutes I checked for missing or faulty stuff. There a couple of assets that will not correct: a PBR-mud 4 asset that says it is "installed from DLS, faulty". Another scrap metal assets says "Open for edit, faulty". But still the main file name is grayed out. Hard to believe a PBR texture and a another simple asset is holding this up.
Any thoughts on what I might be doing wrong? I talked with the designer but he can not see why this will not load. Others have downloaded same file with no issue. I have other routes that I have created or downloaded from a 3rd party that are missing dependencies and they still load and run, just some stuff missing. I can not get this route to the point of verification (no gray) so it does not recognize/show up it when I try to run the route.
I am running a MAC but that has not stopped other 3rd party downloads before.
I looked through the WIKI pages and could not find anything relevant to this issue. Any input you have is grateful. Thanks.