JonMyrlennBailey
Active member
I tried the 10 m masonry black wall but it does not extend down to the floor. Looking under the benches at the floor and the lower part of the room wall near the baseboards, one can see the shadows of rolling stock on the surface above which penetrates the train table (ground) and this is an eyesore. I want panels for my bench work that completely enclose the train table vertically from top to floor.
I am modelling in TS12, not TANE so content must be TS12 compatible.
My train table is about 4 feet (G scale) or 39 meters (actual) above floor level.
BIG or HUGE wall is paper thin and does not work well for train table edges with complex contours like a grand piano case. Thick wall is needed along the edges also for terrain splines to cover dig holes and leave no gaps.
I need something like the standard somewhat-thick black 10-meter-tall wall spline but much taller, 40-50 meters high, with scale-modeling in mind.
I am modelling in TS12, not TANE so content must be TS12 compatible.
My train table is about 4 feet (G scale) or 39 meters (actual) above floor level.
BIG or HUGE wall is paper thin and does not work well for train table edges with complex contours like a grand piano case. Thick wall is needed along the edges also for terrain splines to cover dig holes and leave no gaps.
I need something like the standard somewhat-thick black 10-meter-tall wall spline but much taller, 40-50 meters high, with scale-modeling in mind.
Last edited: