I just drove this route last night, after a long layoff. It is one of those routes where I just enjoy the scenery, and how it "feels". Over the years I have fixed the few unconnected tracks at some of the mines. And made some scenery additions on my clone of it.
The industry tracks at the Tralee mine are PL_Coal. And I had to connect them to the tracks.The switch to the long sweeping track that enters the mine from the East, only worked backwards. I believe I tried flipping the switch around, and also changing the direction arrows, but there were still problems.Then there are quickly two switches (very close together) that choose between Tralee 1 or 2.
Right now, as I approach the mine, I have to remember that this is Tralee, and the switch on the west bound track going into it only works backwards.
On my modified version, I eliminated the third Track (which had no industry on it). I did this to cut down on the number of switches.
Another problem is, if I set the switches manually, I can drive the trains to the industry tracks, load correctly, And continue on properly.. But if I tell a driver to go to either one of the industry tracks, they will not go at all..and the the switches will not change to the proper positions.
It's just one of those things that always disappoints, that's why I'm asking here!
Swordfish, where did you get your improved version? Was it still on the Trainz Pro Routes website or forum?
Thanks fellows, Bob P.