Does this look right to you?
I am using pweiser's Switch wLamp YB for my yard switches and I wasn't too sure about the blue/yellow, I assumed blue=green, yellow=red. The signal placement was by either gfisher or MSGSapper and used the generic Dwarf signal, I replaced them with seniorchief's New Haven High Dwarf V29 which I like a lot but I am unsure of it's accuracy in this location/application.
Is there a simple but good signaling tutorial someone could point me towards? (US 1910-1930's preferably)
Switch machine placement is another thing I'm needing guidence on. My, somewhat flaky, memory of model railroading and prototypes I've seen lead me to believe the switch machine should be between the points and the place where the inner rails diverge, is that correct?
Thanks
Norm
I am using pweiser's Switch wLamp YB for my yard switches and I wasn't too sure about the blue/yellow, I assumed blue=green, yellow=red. The signal placement was by either gfisher or MSGSapper and used the generic Dwarf signal, I replaced them with seniorchief's New Haven High Dwarf V29 which I like a lot but I am unsure of it's accuracy in this location/application.
Is there a simple but good signaling tutorial someone could point me towards? (US 1910-1930's preferably)
Switch machine placement is another thing I'm needing guidence on. My, somewhat flaky, memory of model railroading and prototypes I've seen lead me to believe the switch machine should be between the points and the place where the inner rails diverge, is that correct?
Thanks
Norm