First off, before I make any sessions, I run the route several times in surveyor so that if I find a problem, I can quickly fix it. I'm using RRSignal's Norfolk and Western PL signals on a route I'm working on and I'm having a bit of a problem between them and invisible signals. I have a siding where a engine shed is located, and an invisible signal is located at the switch with the mainline. Whenever the switch to the mainline is set for the siding, I get a red signal. However, when I move my mouse over it in Surveyor, it shows 'Line ahead clear for two blocks'. I must also note that when I flip the switch for the siding, it shows yellow, then quickly changes to red. I've tried several different invisible signals, which are norfolksouthern37's 'invisible signal', <KUID2:45324:24010:3>, 'JR Signal Offset', <KUID2:45324:24900:3>, and cwhitedog's 'Signal Thingy Right (Invisible)', <KUID:93677:1400>. I don't know if it's related to RRSignal's signals or not, but I've never experienced this problem before. Can someone help me out?
Last edited: