Waiting for access to....

[dstelley]

In TS12, I'm trying to use the path rule and the select path in driver.

I have the switches setup and when I "select path" and choose the path I defined, all of the proper switches orient correctly and lock.

But the train that should be using that path will stop on the first one and wait forever with the warning. "Waiting for access to junction {name of junction}

What am I doing wrong?

 

[oknotsen]

Did you by any chance also use the "Set Junctions" rule, set the junction in the right direction but with "blocks AI control"? If so, it will not pass that junction, even when set in the right direction.

 

[Andyz]

In TS12, I'm trying to use the path rule and the select path in driver.

I have the switches setup and when I "select path" and choose the path I defined, all of the proper switches orient correctly and lock.

But the train that should be using that path will stop on the first one and wait forever with the warning. "Waiting for access to junction {name of junction}

What am I doing wrong?

With the path rules you must use commands like "Autodrive to (or Via)" etc. The AI commands like "drive to", "Navigate to etc." can not be used while the engine is passing over any junctions in the path.

Andyz