GoofusClam57
Member
Has anyone else encountered the following problem, and is there anything I can do about it?
I have recently discovered that gondolas, flat cars and certain boxcars (those having doors that open), and that feature load queues with an excess of 8 attachment points, fail to re-render loaded products while in driver mode after scrolling the view camera far away from their train, and then returning. Cars with which I have encountered this issue (just to name a few) include:
<kuid:175455:100671> FCRD 2 P-S 50_6ft Boxcar
<kuid:156765:100631> WP Greenville Gondola
<kuid2:82412:300583:1> TUME-300583-Centerbeam-WP
<kuid:103021:100911> 70ton AAR Flatcar PM
<kuid2:69871:2090:1> Flatcar BNSF 60ft #917504 TS12
<kuid2:46162:15004:10> BNSF Flat car 917504
<kuid2:334896:200053:2> 52ft Bulkhead CTRR 3
The issue is not intermittent, and occurs no matter which product has been loaded, and it is readily repeatable, at least in my installation, which is Trainz TANE SP2-HF1, build 90955.
The issue could have been occurring in earlier builds without my having realized it.
If anyone knows of an adjustment I can make to cause these higher-attachment point queues to consistently re-display loaded products while I drive and scroll around my route, I would very much appreciate hearing from you!
Thanks!
Rob
I have recently discovered that gondolas, flat cars and certain boxcars (those having doors that open), and that feature load queues with an excess of 8 attachment points, fail to re-render loaded products while in driver mode after scrolling the view camera far away from their train, and then returning. Cars with which I have encountered this issue (just to name a few) include:
<kuid:175455:100671> FCRD 2 P-S 50_6ft Boxcar
<kuid:156765:100631> WP Greenville Gondola
<kuid2:82412:300583:1> TUME-300583-Centerbeam-WP
<kuid:103021:100911> 70ton AAR Flatcar PM
<kuid2:69871:2090:1> Flatcar BNSF 60ft #917504 TS12
<kuid2:46162:15004:10> BNSF Flat car 917504
<kuid2:334896:200053:2> 52ft Bulkhead CTRR 3
The issue is not intermittent, and occurs no matter which product has been loaded, and it is readily repeatable, at least in my installation, which is Trainz TANE SP2-HF1, build 90955.
The issue could have been occurring in earlier builds without my having realized it.
If anyone knows of an adjustment I can make to cause these higher-attachment point queues to consistently re-display loaded products while I drive and scroll around my route, I would very much appreciate hearing from you!
Thanks!
Rob