Using AI passenger trains

[RatMaster]

I am trying to get my trains to go to each passenger station the get it to unload then load without using driver commands is the any way to get the trains to go to the station the load automaticly with out having to use the driver command unload and load. I am using 2006

 

[sister]

bah, usually when a industry car arrived to an industry object it load and unload by itself. If I don't remember wrong it should be enough to give the comand "navigate to..." and the name of the place to go to.

 

[shaneturner12]

With some industries (usually passenger stations) if you are not using the load command you need to stop the train between the middle of the industry and the end (the one reason why I always use the load command when sending trains to industries - they simply sit at the entrance to the industry not doing much.

Shane

 

[Azervich]

Hey all,

When I tell AI's Drive To station I always have to add the load command as the loco will always stop just before the station, with the load command it tells the train to drive to the end trigger, if going forward it'll be Trigger_a, if backwards depending on station length and the amount of triggers it can be Trigger_i,k, without the load command it only drives to the closet trigger, meaning forward would be trigger_i,k and backward being trigger_a

-Aaron