Unable to post in Surveyor section, question on 10m/5m Baseboards in TS2009

[Robertd81]

I apologise if this is entirely the wrong section of the forum, but it seems I can't post in the Surveyor section.

Is there a way to change all of the baseboards in a layout to 5m from 10m without needing to click on each and every one in turn? Am working on a Caribbean route based loosely on the Bermuda Railway.

Any suggestions, needless to say, greatly appreciated.

Robertd81.

 

[clam1952]

Afraid there isn't unless you are using a dem made in Transdem, which I believe can produce the 5m grid.

 

[Robertd81]

Not too much of a problem, am doing each section in reasonably small chunks... thanks for the answer though. Looking forward to the day that I finish and upload the route - although am always pleasantly distracted by doing tons of research for it, so it could still be some time away.

 

[clam1952]

Not too much of a problem, am doing each section in reasonably small chunks... thanks for the answer though. Looking forward to the day that I finish and upload the route - although am always pleasantly distracted by doing tons of research for it, so it could still be some time away.

I know the feeling, I've been over 2 years now on my project.

 

[Robertd81]

I hear you on that...

I know the feeling, I've been over 2 years now on my project.

...I was really surprised to see a lack of Caribbean content on the DLS, and went for it - wikipedia has become the route's worst enemy, only yesterday what was to be two hours of construction became four hours of fascinating links. At least the Rhum Islands (the name of my route) will be well thought out. Anyhow, here's to the likes of us.:clap:

 

[Dermmy]

Is there a way to change all of the baseboards in a layout to 5m from 10m ...

Robertd81.

My advice would be "Don't". Only change trackside boards where the terrain absolutely needs a 5m grid. Leave everything else 10m. Lots less load on the computer that way...

Andy