K khenson New member Aug 31, 2012 #1 Is there a command where I can ask a train to remove all passengers when it reaches a terminus for example?? Thanks Keith
Is there a command where I can ask a train to remove all passengers when it reaches a terminus for example?? Thanks Keith
S shaneturner12 Tutorial Creator Aug 31, 2012 #2 There is. It's called Terminate Passenger Train and is available on the Download Station. Shane
S shaneturner12 Tutorial Creator Aug 31, 2012 #4 It's OK - I can find out the KUID for it if needed. (You may even find it built-in in later versions) Shane
It's OK - I can find out the KUID for it if needed. (You may even find it built-in in later versions) Shane
K khenson New member Aug 31, 2012 #5 Shane Could you find KUID as I can't seem to find it on download station. Cheers Keith
S shaneturner12 Tutorial Creator Aug 31, 2012 #6 Firstly, can you check if it's built-in. It may already appear in the list of driver commands that can be chosen from. If it's not already present, it's KUID is <kuid2:116387:16:1> Shane
Firstly, can you check if it's built-in. It may already appear in the list of driver commands that can be chosen from. If it's not already present, it's KUID is <kuid2:116387:16:1> Shane
K KenGreen Active member Aug 31, 2012 #7 I use instant unload this works with passengers. I use it all of the time with ECML where the station has not been passenger enabled. I use this in conjunction with the Load Passengers command which opens the carriage doors. Ken
I use instant unload this works with passengers. I use it all of the time with ECML where the station has not been passenger enabled. I use this in conjunction with the Load Passengers command which opens the carriage doors. Ken
K khenson New member Aug 31, 2012 #8 Shane It is built in--thanks for your help Ken Thanks for your advice Keith
