TS09 crashes in Driver.

[nicky9499]

A session will load normally, the initial starting locomotive with cabview and all with load properly. Then I switch to free camera view, select another locomotive, and poof! Trainz has crashed.

Strange?

Cheerio,
Nicholas.

 

[Napalm]

Hi Nicholas,

Does it give you any error message and are you patched up to the latest (38599) build?

Nathan

 

[nicky9499]

It is non-SP1. This is so that more people may be able to play the route I'm working on when it's released. I understand a route built in SP1 will not work in an older installation?

Cheerio,
Nicholas.

 

[Napalm]

Ok, is this with any particular route or all routes?

I'm running build 38599 and have never had that problem.

Nathan

 

[Euphod]

Are you using compatibilty mode? I have no end of problems trying to get routes to run in 2009!

 

[nicky9499]

Sorry for the late response. Yes Euphod, it's in compatibility mode. Occasionally I'm able to switch locomotives once or twice before it decides to crash. But now there's missing textures (all white) on some assets, for example mfm prime mover and California tunnel splines. I'll get around to reinstalling when I suffer from Trainz-burnout. No cause for worry, thanks for all the input by everyone.

Cheerio,
Nicholas.

 

[Jayturf]

I also have a problem where if i'm driving in any view and switch to the map view...my engine dies..after it comes to a complete stop i can go agian...but it is really anoying especially on a 4.78 grade!