Trouble in the Roundhouse

[raymac1946]

I've been trying to edit a session in the Cattaraugus Creek 1950s route. I place a locomotive in the roundhouse, then select either move or fine adjustment tool to move the loco back inside. Instead the tool always selects the roundhouse assets which I don't want to move - that causes further problems such as saving the route a second time rather than the session. What am I doing wrong here? Is there any way to avoid selecting the roundhouse and just select the loco? This is with Surveyor 2.0.

 

[Forester1]

Unfortunately, Trainz has a tendency to grab the largest thing nearby and ignore the smaller thing you want. I have read that it might be possible to put something like the roundhouse in another layer so it doesn't affect the locos, but I have not tried layers.

 

[Fierogt87]

I've been trying to edit a session in the Cattaraugus Creek 1950s route. I place a locomotive in the roundhouse, then select either move or fine adjustment tool to move the loco back inside. Instead the tool always selects the roundhouse assets which I don't want to move - that causes further problems such as saving the route a second time rather than the session. What am I doing wrong here? Is there any way to avoid selecting the roundhouse and just select the loco? This is with Surveryor 2.0.

You can set the asset browser to "Filter Selection"

An then click the "train Filter".

Now only train items can be selected.

 

[raymac1946]

Thank you. That was exactly the fix I needed.