Train stopping outside the platform

[awsd]

I sent order to the AI to stop at the station(passenger enable ones)and then load, the AI proceeds to complete the given order however there is a problem, the front of the train stops outside the platform. I tried use track marks but to no avail. Is there any solution to this?
By the way is on TRZ2006.

 

[cascaderailroad]

A train will stop 20m short of a trackmarker, if your train is speeding at a high rate, it might slide right on through a trackmarker that takes AI by suprise ...so you would need to slide the trackmarker backwards to get the train to stop earlier ... and too, place ever slower incremental speedboards to slow a train from down from120km ... to 60 km, to 30km, to 15km to make more gradual stops.

I know some excellent imperial, and metric speedboards, some are invisible in driver.

A train traveling down a steep slope, may not be able to stoop completly, and may continue to slide, with it's wheels locked up.

A train will immediately slow by seeing a lower speedboard ... but will only speed up to a higher speedboard, once the last car passes.

 

[JCitron]

I sent order to the AI to stop at the station(passenger enable ones)and then load, the AI proceeds to complete the given order however there is a problem, the front of the train stops outside the platform. I tried use track marks but to no avail. Is there any solution to this?
By the way is on TRZ2006.

Are you using the Drive To (fill in your station name here) followed by the load command?

This combination will ensure that the AI driver runs the station script other wise the AI will stop outside the station or skip past it.

John

 

[llebrez]

It used to work as prescribed. Now, use KUID:458053:100327 (Invisible platform 50mts, or any of the length variations), and follow with the "load" or "Unload" command, or no command. And see that the train stops just at the border of the platform. Why? Because it is considered an Industry, you have to use the "Drive/navigate" to command.