Tough curves on some routes...

[Steamdemon]

What I mean by tough curves is that trams cannot corner easily sometimes... I also know that only a few steam trains and diesels can handle tramway curves easily... But why isn't a tram able to corner a curve that is designed for it? This was evident when I took my ICE tram out for a spin... Probably on the last curve on the hampshire mall route (I think that is what it is called), the tram's controls stopped responding, and I could only go backwards...
There were no derailment marks above the train, and it could go backwards, but only slowly...

What has gone wrong with the route?

EDIT: I have a feeling this post will be forgotten....

SECOND EDIT: Yes, I have a habit of putting EDIT on a post that I have edited. Do not be alarmed...

 

[Deano5]

That is a funny one. I tried the MP tram route and session last week and could not get the first few trams out of the shed, got the last one out but it got stuck on another corner in the route. Most of the curves are way too tight.

 

[JohnnyC1]

If you are in DCC mode switch to CAB and then back to DCC, make sure you have Quick Drive installed so that you can alternate in a drive session.

Johnny