Taking screenshots and Junctions

[VL1238]

Hi all,

I have two questions I would like some help on:

First, how can I take higher quality screenshots? Whenever I do take a shot with normal print screen, it comes out OK but is not as clear as I would like it to be.

Second, in surveyor, can you somehow stop the names above the track junctions from appearing?

Thanks in advance

 

[captainkman]

Hello!

Before you start Trainz, go to Options at the Launcher, and go to Display settings. Make sure Trainz is running at your monitor's current resolution.

I don't think Ctrl + H works in Surveyor, and I can't be bothered checking.

Hope this helps. (Well, the first part anyway!)

Kieran

 

[AntonyVW]

Not sure about first question but for second one. In driver got to the menus on top right - third icon from left. You can turn them off there

 

[Enkidoh]

CTRL + H does the same in Driver (toggles the junction names/point direction on and off), but the original poster was asking if that's possible in Surveyor, which I don't think it is, short of removing every point lever or point motor attached to every junction on the route!

As for screenshots, you can also use a program like FRAPs to take screenshots as well, but doing that is wasteful when Trainz itself takes good enough screenshots - if your screenshots are coming out blurry or poor, then it's likely you need to tweak your graphic settings for Trainz, as Kieran mentioned.

 

[VL1238]

Thank you everyone for your help!

 

[vosloo]

With regard to the junction names try the folowing - In surveyor go to options > Surveyor settings > tick Limit contextual information. This is for TS12 but for 2009 it ought to be about the same. The names will now only show when you are in Tracks/Objects tab or when you move the curser over the junction.