Sporatic Junctions Cause & Solution ?

[yukontookon]

Does anyone know what can cause junctions (turnouts) to behave sporatically. They will function properly in Surveyor, as well as when I start a session. But after I have saved the session a few times, then some of the junctions do not function. The overlay arrows are red in both directions and the junction does not function. Any clues ? I am using Trainz Simulator 12, Build 49922.

 

[mastercool9]

i am pretty sure you can't save your session unless you build in route only and make changes in route only.

 

[yukontookon]

So you can't make and save changes using Surveyor via "Edit Session" ??? The changes seem to work a while in subsequent operating sessions (while I'm operating in different parts of layout, but check back and turnouts are ok), but then eventually the turnouts "go bad".

 

[shaneturner12]

You can save a session in Surveyor, but don't do so if you have saved a driver session (i.e. using the Save command in Driver) for that session. Basically, once a route/session is modified in Surveyor, any sessions saved in Driver for that Surveyor session will no longer work correctly.

Shane