I'm using the GRS signals that are available on the DLS and I'm running into some problems setting them up.
1. How do you set up signals to protect the end of a double track line. I've put a single 3+3+0 on the single track end, but the 3+3+0's I put on the double track side stay red. Also, I tested the single track signal in the surveyor, when I flipped the switch to the mainline, it's fine, but when I flip the switch to the passing siding, the lower head flashes between red and green.
2. I've set up a few intermediate signals, but they want show anything except Yellow or Red.
3. Is there anyway to make the signals show anything other than red when there's not a train in the block. I plan to use my route to make videos and they don't operate like I'd like them to.
1. How do you set up signals to protect the end of a double track line. I've put a single 3+3+0 on the single track end, but the 3+3+0's I put on the double track side stay red. Also, I tested the single track signal in the surveyor, when I flipped the switch to the mainline, it's fine, but when I flip the switch to the passing siding, the lower head flashes between red and green.
2. I've set up a few intermediate signals, but they want show anything except Yellow or Red.
3. Is there anyway to make the signals show anything other than red when there's not a train in the block. I plan to use my route to make videos and they don't operate like I'd like them to.