Question about the red and green arrows on junctions

[jjslll54]

Hello,

I'm asking if there are invisible junctions with smaller arrows for driving on roads with invisible track. All of my roads are going to be driveable when I am finished with my route. As you can see in the picture below the arrows are rather large for a roadway as they overlap each other. Any help or instruction on how to change the arrow size (if doable) would be greatly appreciated. If not, maybe this could be done for the next version of trainz? The new version will out long before I get finished with this, so I can wait if I need to. Thanks in advance.

 

[p-dehnert]

You could use the builtin (TS12, TANE) rule <kuid:-25:791> Set Helper Icon Size. Add it to the session rules, and edit the rule to scale the size down.

Peter

 

[Roy3b3]

Or, you could hit 'Ctrl - H' when you start Driver and it will hide all junctions and overlays.


Cheers,
Roy

 

[jjslll54]

Thanks Peter. That solved my problem nicely. Roy, Hiding the icons would make it a bit hard to navigate the roads in your driveable vehicle. I am adding invisible track to my roads so you travel my routes by car or maybe even add in bus routes for towns. This will allow users to do some train spotting or chase trains like it is done in real life. Thanks, both of you for responding to my query.

Jacob

 

[cascaderailroad]

I seen absolutely no reason at all why there are "Red" arrows, at all, that just clutter up the screen ... when all that are needed is subtle, small, green arrows, that do not block the screen

Why are the so huge, anyway ?

 

[CeeBee]

I seen absolutely no reason at all why there are "Red" arrows, at all, that just clutter up the screen ... when all that are needed is subtle, small, green arrows, that do not block the screen

Why are the so huge, anyway ?