Procedual Track problem

[Firefighterdan]

I am changing all the track on my currant route to procedual track and have this problem on a couple different switch points and not sure how to fix the problem. Any help will be much appreciated, Thank you!

 

[JCitron]

Make the angle of the diverging track larger.

I generally make the angle so that the outer circle of the spline point just touches the ties of the through track. You may also need to shorten the length too of the switch as well.

 

[fant_autentico]

There is no switch on that track, remove the switch from track objects.
Let's see if it works.

Regards

 

[JCitron]

There is no switch on that track, remove the switch from track objects.
Let's see if it works.

Regards

You're right, I didn't notice that!

There is probably though, a tiny twist in the track buried underneath caused when laying the track.

 

[Firefighterdan]

Both tricks did it! Thank you Guy's!!! :wave:

 

[pware]

The red spline circle on a procedural track junction can be caused by:-

• one of the diverging tracks has a curve radius that is too small
• attached track splines not level
• one of the attached tracks is not a procedural track

to which I can now add

• a switch is present but no joining track

 

[Firefighterdan]

The red spline circle on a procedural track junction can be caused by:-

• one of the diverging tracks has a curve radius that is too small
• attached track splines not level
• one of the attached tracks is not a procedural track

to which I can now add

• a switch is present but no joining track

There is a joining track but it was way too long so I shortened it up along with a couple other junctions.