Here's my problem: I've put some flora objects into a mesh library to use with my new route. None of them are showing errors in TS12, build 3.5, and all of them appear and can be placed in Surveyor. However, most, but not all, of the objects are completely unresponsive in Surveyor - ie. no rotation, height adjustment, movement or deletion once they've been placed.
I've never seen this behaviour before with objects in Surveyor. My initial thought was that maybe this was a problem with layers. However, placing these objects on an empty baseboard with only the Route-layer, produced the same behaviour.
Is this possibly a problem with the mesh library asset? It seems strange though that some of the objects in the library work fine, while others don't.
Any suggestions or ideas are welcome - this problem is holding up the release of my route!
Paul
I've never seen this behaviour before with objects in Surveyor. My initial thought was that maybe this was a problem with layers. However, placing these objects on an empty baseboard with only the Route-layer, produced the same behaviour.
Is this possibly a problem with the mesh library asset? It seems strange though that some of the objects in the library work fine, while others don't.
Any suggestions or ideas are welcome - this problem is holding up the release of my route!
Paul