NYCTA Subway Question

[aking4125]

I just got my copy of Trainz Simulator 2010.

I downloaded NYCTA 2007 route and I must say. Very good job here. My question is this: Is There A way to make the AI drive from station to station in order, (3rd Ave - Grand Concourse - 125th ST ETC) stop at each station, then repeat it backwards? I cannot do this at the moment. Normally, there is a "Drive To" command but there isn't. All I can do is run the trains in "Auto Pilot" mode and let them drive until they reach the end of the tracks. I don't want this. I hope I was clear with all this. Can anyone help me out on this?

 

[chrisjohn]

If you have previously downloaded the drive-to command, then all you need to do is enable the command in driver commands in surveyor, for it to become available to drivers.

 

[Approach_Medium]

I just got my copy of Trainz Simulator 2010.

I downloaded NYCTA 2007 route and I must say. Very good job here. My question is this: Is There A way to make the AI drive from station to station in order, (3rd Ave - Grand Concourse - 125th ST ETC) stop at each station, then repeat it backwards? I cannot do this at the moment. Normally, there is a "Drive To" command but there isn't. All I can do is run the trains in "Auto Pilot" mode and let them drive until they reach the end of the tracks. I don't want this. I hope I was clear with all this. Can anyone help me out on this?

Where did you DL NYCTA from? I would be very interested in that route.

Thanks

FW

 

[strench707]

Its on the DLS:

http://www.auran.com/TRS2004/DLS_viewasset.php?AssetID=98548

Not the highest quality route but worth checking out I guess,

Davis

 

[aking4125]

If you have previously downloaded the drive-to command, then all you need to do is enable the command in driver commands in surveyor, for it to become available to drivers.

That doesn't work....even when its "enabled" it just doesn't show up when I right-click on them.