NYC Heavy 2-8-2 download problem

[umphies]

Thisismeagen,
I have just down loaded the NYC Heavy 2-8-2 KUID 26718:1383 which was only put in on the 6th and when I go to use it it is not there...Trainz objects sez that 'interior - kuid 96914:55201' and 'hornsound kuid 96914:54104' are missing. Cannot find them in download station...Is it just me or do others get the same problem..there have been aprox 474 downloads of this asset so far but no queries in forum yet (except me of course) Do these others know something I don't know (which is almost everything)...I have tried using different interiors and hornsounds in the config files but to no avail...

Thanksandthatsallfolks...

 

[Euphod]

I have tried using different interiors and hornsounds in the config files but to no avail...

I'm assuming you changed the kuid reference numbers in the configfile to point to different interiors and hornsounds which I then further assume are installed and not faulty or missing dependencies on your PC.

Having accomplished that, have you changed the same kuid numbers in the kuid table at the bottom of the configfile?

 

[westend531]

NYC Heavy 2-8-2

I also had problems with this not appearing. I got the same result when I used Trainz Objectz to look for missing items, not found on DLS. I changed the horn sound, engine spec and interior KUID to ones that I know work. I then was able to view the loco in Railyard and place it on a map in Surveyor.

Now my problem is this. When I go to Driver all is well until I select the NYC Heavy 2-8-2 and then I instantly get an error message concerning "stack dump regulator setting not found". I have an option to continue or abort. If I click continue I just keep getting the same error message popping up over and over again and nothing continues. Naturally selecting abort ends the program.

Too bad as this is a very well done model and I would like to run it and not just have it sitting on my layout unable to move. I checked the config file but did not find any reference to regulator setting.

Any ideas?

Thanks, westend531

 

[bdaneal]

Read the thread on that engine. All the information you are asking about has already been posted there.

Cheers,
Ben

 

[umphies]

Thanks Ben,
Tried your suggestion and finally got it right....

So thanks again..Cheers too..

 

[Zorronov]

I'm glad you got it sorted out. Thanks again, Ben.

Cheers,
Fred