NSW Shunts 2st and 4st signal problems

[jetpilot29]

No information tracks??????

Jason

 

[usaoz89]

i thought it does not show anything when you look at the imformation of a trackside object
also is this in the wrong forum?

 

[jetpilot29]

This shown should be in shunts properties "Enter stencil" with add junctions

2st = 2 list "enter stencil"
4st = 4 list "enter stencil"

Example:

Hope this help.

Jason

 

[mattm]

Jason.

The NSW Shunt signals by Natvander are not programmed to display any asset other than the standard Caution & Danger indications
I believe this is because they were created for an older version, where such advanced scripting was not yet possible, however i could be (and most probably will be:hehe wrong.

Feel free to correct me if you wish.

Matt.