NormP's Brisbane and Gold Coast Routes

[c38nsw]

Hi all,

I am having trouble merging these two routes together.

If someone could do one of the two following things would be great;

1. Go to this link http://forums.auran.com/trainz/showthread.php?t=67271&highlight=ts2009 - It has what my problem is, and then please reply if you have any more help

OR

2. If you have these two routes merged together in another version of trainz, could you please send it to me.

Thanks c38nsw.

 

[NormP]

c38nsw.
It as a common (well Known) problem with merging Maps in some versions of trainz, that these "chasm's" appear, mostly at the merge joint of two Maps, the only remedy is to flatten (or raise) the ground,if it is on level terrain ? then I use a length of single track along one side of the chasm,make sure the spline height is set and then use the smooth tool to raise the ground up to required height,if the full width of the gap hasn't closed then just move the track across and smooth again,some times the texture will have dissapeared as well and needs replacing.
If the terrain on each side of the chasm is hilly it takes a little more work and patience. to use the track method I don,t "set" the spline height but run the track up and down the hills alongside the chasm with a number of spline points too match the hills,then use the smooth tool to raise the ground.

You will have to check at nealy all "train stations and industries" for track that has been disconnected
Perhaps you can over come some of the problems in this way ?

NormP.

 

[Petan]

Hi c38nsw,

You did not mention the following worthwhile route. I assume you know about it?
Wynnum to Cleveland by PEV. An extension of NormP's Brisbane South

Cheers
Peter C

Hi all,
I am having trouble merging these two routes together.
Thanks c38nsw.