I have an issue migrating a route/session from 2019 to 2022. Very puzzling.
I have this route which works fine in 2019. Everything runs as expected. No errors on any of the assets.
I save the route/session to a CDP. I then import the content file into 2022+. Again, no errors with any of the content. I then open up Trainz and select this route/session to open in Surveyor 2, which it does fine. From the session I select "drive train" and everything is fine. I quit by exiting the driver mode, with no saves. I open up the route and repeat and again everything is fine. I again exit driver with no saves. I then enter surveyor again and make some changes and save these to the route and session, and then exit. This is where the problems begin.
When I now startup in the surveyor mode (surveyor 2) and execute the drive command things don't work properly with some of the consists and passenger stations. One example is that a consist will go to a passenger station and load up but then just sits there. Also, some of the portals are not emitting properly. The consist is formed properly and proceeds to the mouth of the portal and just sits there and will not exit. I have tried switching out the stations involved, but that does not help. The same with the portals.
There must be something in the 2019 code which does not agree with 2022.
Any thoughts?
I have this route which works fine in 2019. Everything runs as expected. No errors on any of the assets.
I save the route/session to a CDP. I then import the content file into 2022+. Again, no errors with any of the content. I then open up Trainz and select this route/session to open in Surveyor 2, which it does fine. From the session I select "drive train" and everything is fine. I quit by exiting the driver mode, with no saves. I open up the route and repeat and again everything is fine. I again exit driver with no saves. I then enter surveyor again and make some changes and save these to the route and session, and then exit. This is where the problems begin.
When I now startup in the surveyor mode (surveyor 2) and execute the drive command things don't work properly with some of the consists and passenger stations. One example is that a consist will go to a passenger station and load up but then just sits there. Also, some of the portals are not emitting properly. The consist is formed properly and proceeds to the mouth of the portal and just sits there and will not exit. I have tried switching out the stations involved, but that does not help. The same with the portals.
There must be something in the 2019 code which does not agree with 2022.
Any thoughts?