Loco’s not moving.

[RBRUUN73]

Installed Trainz22 on an external drive, moved the container for com.n3v etc from main hard drive to external drive. (Mac)

When I load a train and use simple throttle, engine does not move or even sounds don’t change to show throttling up.

 

[pware]

I don't have a Mac but a few questions that might help.

By "simple" throttle I assume that you mean using the "W", "S" and "X" keys? Do other keys work correctly? Are you using a wireless keyboard?
Is this a new install? Have you had TRS22 installed before and did not experience this issue?
Does this occur with other locos, or is it just a specific one?
Is the loco with a consist parked at an industry?

 

[RBRUUN73]

Keyboard works fine, throttle worked fine before when I had it on my main drive, but moved it to an external drive and no locks run now.

 

[mtldrm38]

This may not be your situation but I had that happen to me and found if you are using schedule commands or portal commands the day and time have to be the same....

 

[JCitron]

TRS22 isn't paused is it?

If not, try a database repair and if that doesn't work try an Extended DBR by pressing CTRL while clicking on Rebuild Database.

As always, when you finish any database repair, check for faulty assets. If you have any, select all and view errors and warnings to clear them. You may have to exit from that view and then go back in and check to refresh the database.