Junctions that need wiring not working right in TS2012...

[RailFan500CA]

Yes,as the title says,I am having issues with junctions that are objects with wiring required. Say,Andi06's old JK junction sets,if I try to wire it,I can start it on the object... then when I try to attach it to the other end,it will not connect,so that makes me have to start another wire (Which is an invisible track.) and attach it to the other wire,remove the spline point in the middle,then I get a straight,and that is not the same story for the rest of it,which is inconvenient.

Would there possibly be a solution to this...

 

[p-dehnert]

The manuals for the AJS Junction Kit are downloadable at the wayback machine (Getting started and manual).

Peter

 

[teddytoot]

Basically for a simple point, using Andi's junction rail (eg green):

Wire a length from a green diamond on the straight out to the side.
Wire from that point to the green diamond by the red one
Wire a length from the curved green diamond to join the spline point at the side and a junction will be formed
Move that junction to coincide with the red diamond; the more precise you can be, the smoother will be movement over the point

For slips you need to download the manual as mentioned by Peter. They need to be coded as instructed. This works in TS12 but I can't get it to work in TANE SP2. In passing I have just discovered that his later "pre-wired" points won't work in TANE SP2.

 

[BuilderBob]

...so that makes me have to start another wire (Which is an invisible track.) and attach it to the other wire,remove the spline point in the middle

That is the correct procedure with TS12.