Why is it that if I use a semaphore with a left branch it always signals straight ahead regardless of the switch setting ? I've tried various combination of signals and track layouts but the junction signal always remains the same. Any help would be appreciated.
Chances are you are missing a signal ahead of the branch signal as in the signal ahead is missing Hover the curser over the signal and it will tell you so, to clear the problem with crossovers use invisible signals Also check and be sure that you have the junction leave slightly outside the spline point on the approach side Also place a rolling stock item on the track in surveyor to check the operation If you have downloaded any of my routes take a look round in surveyor for examples Regards Bob V
