JK points direction

[Approach_Medium]

Hi;
When I enter Driver in TS2010, I find that some of the points on the JK junctions are not in the position that is indicated by the green/red arrows.
Changing the direction, then back resets the points and then they always follow the arrows.

Is there something I am not doing correctly here?

The JK junction (the scenery object and the track) are all on the Route layer.

Thanks for your help

FW

 

[bchester]

Hi;
When I enter Driver in TS2010, I find that some of the points on the JK junctions are not in the position that is indicated by the green/red arrows.
Changing the direction, then back resets the points and then they always follow the arrows.

Is there something I am not doing correctly here?

The JK junction (the scenery object and the track) are all on the Route layer.

Thanks for your help

FW

You need to use the JK Junction controller - only one is required - to have the junctions set to the correct paths when starting a session. Also, be warned that it could cause a long delay when starting a session if you use a lot of junction. I use over 2000 on my CPR Winnipeg division and it takes about 10 minutes to start up when the controller is present.

Hope this helps some

Bricey

 

[Approach_Medium]

Thanks for the info. I seem to recall having once used the JK controllers, but have forgotten to place them on my current route.

I only have a few of the JK junctions so far, and was only planning to use them on the mainlines.

Do the junction controllers cause a perf hit once the session is started?

Edit: It's called "JK Control Box" started searching for JK junction controller but only came up with the one by Mizi.

FW

 

[bchester]

Edit: It's called "JK Control Box"
FW

Sorry bout that, the memory is getting really bad in my old age! There is no perf hit that I know of once the session actually starts - just the start up that takes a while (for me anyway with all the turnouts I have)

Bricey

 

[gary6204]

i have had this problem with the default junctions.... exept it doesnt fix itself