Is there an alternative to ajs...?

[AntonyVW]

I am having constant issues with the ajs invisible stations and I was wondering if there were any alternative to them? My current issue is that I have a double track line going into a terminal station, which as it does so divides into 6 platforms. Because the ajs 6t invisible platform is usless the largest I can use is the 2t variety. My problem is that no mater how I set up the platforms, the trains will only go to 2 of the 6 platforms unless I give each pair of platforms a different name, which is not helpful. So as I said is there an alternative to them?

Edit: I should add this is for a UK station at 1.3m height

 

[Kennilworth]

Hi

You can put a trackmark by the buffer stops on each platform and tell the train to drive to the appropriate one. You may have to adjust the trackmark radius until you get the train stopping in the correct place.

Regards

Brian

 

[CoachMan888]

Alternatvely give your stations a different thus:

Your station name [platform number : description ]

So for example a scenario you decribe with 3 x 2t stations making 1 x 6t could be:

1st 2t = Town Station [1&2:Main]
2nd 2t = Town Station [3&4:Local]
3rd 2t = Town Station [5&6:Releif]

Note the use of SQUARE brackets.

In surveyor bring up the help and configuration page (icon lower right corner). Click the help icon and a fuller description is available including the use of the CALL AT driver command which takes your 3 x 2t stations, and by virtue of them all having the same station name, treats them as one station.

HTH

 

[stagecoach]

There are 2, 4, 6 and eight track terminus stations available UK versions. But if you want invisible ones and need the three you have just name them as Town P12, Town P34 and Town P56. I think there is a drive to command that will list all three under the one name, but would need to check if im right.